Search results
Jump to navigation
Jump to search
Create the page "Grove" on this wiki! See also the search results found.
- ...se download and read through Preface - Getting Started and Introduction to Grove before your using of the product.2 KB (315 words) - 06:16, 22 August 2019
- *Standardised Grove Interface VCC and GND of the Grove interface are routed out as two buses as shown above. You can find solderin2 KB (382 words) - 06:19, 22 August 2019
- ...the module to the Analog port 0 of Crowtail - Basic Shield using the 3-pin grove cable.3 KB (360 words) - 05:22, 22 August 2019
- Connect it to A0 port of Crowtail - Base Shield,Plug the Grove - Base Shield into Arduino/Crowduino and connect them to PC using a USB cab2 KB (331 words) - 05:28, 22 August 2019
- #define Crowtail_VCC 5//VCC of the grove interface is normally 5v3 KB (375 words) - 05:31, 22 August 2019
- * 3 GROVE-compatible connector: I2C, Analog, Digital ...the various components [//www.seeedstudio.com/depot/Grove-t-3.html?ref=top GROVE] from Seeed Studio.10 KB (1,453 words) - 04:25, 22 August 2019
- ...onnect other sensors [http://www.seeedstudio.com/wiki/GROVE_System (series Grove)] or actuators to this platform, to build your remote monitoring or control4 KB (581 words) - 04:28, 22 August 2019
- [[Image:Grove - Electricity Sensor hardware1.jpg|500px]][[Image:Crowtail - Electricity Se4 KB (540 words) - 06:07, 22 August 2019
- *GROVE-compatible connector: I2C Additionally EM Shield can connect any device using i2c Grove-compatible connector (sensors, displays, etc.).8 KB (1,056 words) - 04:17, 5 August 2021
- *Grove CrowtailGrove - MP3 v2.0 × 13 KB (468 words) - 06:19, 22 August 2019
- Connect the Grove - Gas Sensor(MQ2) to A0 port as shown in the above picture.<br>5 KB (785 words) - 06:05, 22 August 2019
- ...tomatic degaussing strap drivers and offset cancellation are inbuilt. This grove module also includes a MIC5205-3.3 for power supply requirement. Hence user10 KB (1,254 words) - 06:08, 22 August 2019
- It is possible to connect the Grove module to Arduino directly by using jumper wires by using the connection as6 KB (811 words) - 06:06, 22 August 2019
- *I2C and Serial Grove compatible connector.6 KB (915 words) - 03:40, 22 August 2019
- This means that if you try to add another serial device ie grove serial LCD you may get communication errors unless you craft your code care32 KB (4,786 words) - 06:46, 5 August 2021