Currency
Toggle Nav
ESP8266 IOT Board
was
$8.90
Special Price
$3.56
Availability:
In stock
SKU
DPO82666E
Brand
elecrow
Weight
11g
Related Products:
×
Add to cart successfully!
Add to cart successfully!
Customers Who View This Item Also Bought
【ESP8266 IOT Board】ESP8266 @ 80MHz, 3.3V logic/power, with 4MB flash memory (32 MBit)
【Wireless Connection】Built-in WiFi 802.11 b/g/n
【Serial Converter】Onboard CP2012 USB-Serial Converter, the maximum upload baud rate is 921600
Frequently Bought Together
Description
This is an ESP8266 IOT board- our take on an 'all-in-one' ESP8266 WiFi development board with built-in USB and battery charging. It’s an ESP8266 WiFi module with all the extras you need, The most important part is an ESP8266 WiFi microcontroller clocked at 80 MHz and at 3.3V logic. This microcontroller contains a Tensilica chip core as well as a full WiFi stack. You can program the microcontroller using the Arduino IDE for an easy-to-run Internet of Things core. We wired up a USB-Serial chip that can upload code. It also has auto-reset so no noodling with pins and reset button pressings. To make it easy to use for portable projects, we added a connector for 3.7V Lithium polymer batteries and built-in battery charging. You don't need a battery, it will run just fine straight from the micro USB connector. But, if you do have a battery, you can take it on the go, and then plug in the USB to recharge. The board will automatically switch over to USB power when it's available. Comes fully assembled and tested, with a USB interface that lets you quickly use it with the Arduino IDE or NodeMCU Lua. (It comes preprogrammed with the Lua interpreter) We also toss in some header so you can solder it in and plug it into a solderless breadboard. Lipoly battery and USB cable are not included (but we do have lots of options in the shop if you'd like!)
Features
- Sizes: 50mm(length) x 35mm(width)
- lightweight
- ESP8266 @ 80MHz with 3.3V logic/power
- 4MB of FLASH (32 MBit)
- Built-in WiFi 802.11 b/g/n
- 3.3V regulator with 500mA peak current output
- CP2012 USB-Serial converter onboard with 921600 max baud rate for uploading
- Auto-reset support for getting into bootload mode before firmware upload
- 9 x GPIO pins - can also be used as I2C and SPI
- 1 x analog inputs 1.0V max
- Built-in 100mA LiPoly charger with charging status indicator LED, can also cut a trace to disable the charger
- Pin #0 red LED for general purpose blinking. Pin #2 blue LED for boot loading debug & general purpose blinking
- Power/enable pin
- 4 mounting holes
- Reset button
Package list
- ESP8266 IOT Board x 1
Wiki & External links
Write Your Own Review
Bestselling Products You May Like
New Products You May Want
All-in-one Starter Kit for Pico 2|RP2350 Starter Kit: 17 Sensors & 21 Coding Lessons
was
$37.99
Special Price
$32.29