Climber - Intermediate Development Kit for Arduino

• LED flashing experiment;
• PWM control light levels experiment;
• Advertising light water experiment;
• Button control LED experiment;
• Traffic light design experiment;
• Responder experiment;
• Buzzer experiment;
• Analog values reading experiment;
• Light control sound experiment;
• Photosensitive lights experiment;
• LM35 temperature sensor experiment;
• Tilt switches experiment;
• Flame alarm experiment;
• 4-bit digital tube display experiment;
• 74HC595 application experiment;
• Servo control experiment;
• Infrared remote experiments;
• 1602 LCD module experiment;
• PS2 joysticks experiment;
• Stepper motor experiment;
• Tri-color RGB module experiment;
• Relay module experiment;

Partlist

• 1 x UNO R3 board
• 1 x Prototype shield
• 1 x 830 hole breadboard
• 10 x Red light LED
• 10 x Green light LED
• 10 x Yellow light LED
• 10 x 10K resistors
• 5 x 1K resistors
• 8 x 220R resistors
• 1 x 74hc595
• 1 x Active buzzer
• 1 x passive buzzer
• 1 x Eight-segment display (1digit)
• 1 x Eight-segment display (4digit)
• 10 x Push button switches(Big)
• 4 x Push button switches(Small)
• 3 x Photo resistors
• 1 x Adjustable resistor (Potentiometer)
• 1 x LM35 temperature sensor
• 1 x Flame sensor
• 1 x Infrared receiver
• 2 x Tilt switch sensor
• 1 x Remote control (1 x CR2025 included)
• 1 x 1602 LCD display
• 1 x PS2 joystick
• 1 x Stepping motor
• 1 x Stepping motor driver board
• 1 x Servo motor
• 1 x RGB module
• 1 x Relay module
• 30 x Jumper wire
• 10 x Dupond wire
• 1 x 2.54mm straight 40 pin header
• 1 x USB cable (40cm)
• 1 x AAA Battery box
• 1 x Double storage box

Download

• Learning Material
• Getting Started with Arduino