Serial CAN Bus Module

The Serial CAN Bus module enables your Arduino to communicate with a CAN Bus system, allowing you to access and manipulate messages on the bus. It connects to your Arduino through the on-board Grove connector.

CAN Bus is a communication protocol that enables microcontrollers and sensors within a vehicle to communicate with each other. It offers long distance, moderate communication speed, and high reliability.

The Serial CAN Bus module is based on the MCP2515 CAN controller and MCP2551 CAN transceiver, providing a maximum speed of 1Mb/s. It also has a terminal block, allowing you to connect to your vehicle's OBD-II port with just two wires.

This product has been certified by CE and FCC, and you can download the certificate in the Preferences section.

We have just released a new CANBed with an aluminum alloy case. If your product needs a casing, we recommend you check out this new product.

Part List:

• Serial CAN Bus Module x1
• Grove Cable x1
• Screw Driver x1

Features:

• UART to CAN Bus communication
• Compatibility with Arduino, BeagleBone board, Raspberry Pi, and other microcontrollers that support UART
• Support for AT commands
• UART baud rate up to 115200 (default 9600)
• CAN Bus baud rate up to 1Mb/s
• LED indicators for TX and RX, and power
• 4-pin Grove connector
• 2-pin screw terminal block
• Operating voltage: 3.3/5V
• Easy-to-use Arduino library
• Small size: 20x40 mm

Peferences:

• Serial CAN Bus Module Docs
• Arduino Library
• Serial CAN Bus Schematics
• CAN Bus Products - Selection Guide

• CE Certification
• FCC Cerfitication
• European Declaration of Conformity

Certification

This product has been certified by CE and FCC, and you can download the certificate in the Preferences section.