Two-part 3D-printed PLA case for the IronBCI-32 32-channel EEG board.
IronBCI-32 board sold separately. Research & education use only, not a medical device.
A two-part 3D-printed PLA case for the IronBCI-32 board. The board sits on six posts in the bottom tray, the lid closes over it, and four screws from underneath hold everything together. All four electrode headers and both Micro-USB ports stay reachable from the sides, so you can plug in electrodes and cables with the case closed.
| Compatible board | IronBCI-32 (70 × 70 mm regular octagon, 1.6 mm PCB) |
| Material | PLA (non-conductive), FDM 3D printed |
| Printed parts | 2 – bottom tray and lid |
| Bottom tray | 76.4 × 76.4 × 12.2 mm |
| Lid | 76.4 × 76.4 × 16.6 mm |
| Assembled size | approx. 76 × 76 × 29 mm (electrode header pins stick out about 3 mm on each side) |
| Board mounting | 6 posts matching the board's 6 mounting holes |
| Fixing | 6 × M2.5 × 16 mm Screws |
| Openings | 4 electrode header sides, 2 Micro-USB (Power, Data Stream), 2 button holes in the lid |
| Weight | approx. 30–40 g |
Assemble with no cables connected. With the case closed, the four electrode headers stick out about 3 mm on each side, and the Micro-USB ports marked Power and Data Stream sit in the open corners.
Do I need to open the case to connect electrodes or USB?
No. The four electrode headers stick out through the open sides of the lid, and the Power and Data Stream Micro-USB ports sit in the open corners.
Why do the screws go in from underneath?
The screw holes open on the bottom of the tray. Each screw passes up through a post and the board's mounting hole into the lid, so one screw holds all three parts together.
Does the case make IronBCI-32 safe to use on mains power?
No. The case is a mechanical cover only and adds no electrical isolation. Keep following the battery-only rules: board on a 5 V USB battery, laptop on its own battery, unplugged from the wall.
Is PLA suitable for this case?
Yes, at room and body temperature. PLA softens at around 55–60 °C, so don't leave the case in a hot car or in direct summer sun.